1. Remove the printhead to reload once with a cleaning program to automatically clean it, see the print effect. General printer will have automatic cleaning nozzle program, you can open the top cover of the inkjet printer, the printer’s printhead will automatically slide to the middle of the position, the print color distortion of the nozzle removed, then installed on the next, the printer will start to clean the printhead of the program, the general nozzle blocking is not much so that it can be used normally, print a color picture, to see the effect.
2. with absorbent cotton paper, dipped in water, gently scrub the printhead, and print to see the effect. When found on the picture or fuzzy handwriting, horizontal lines or broken lines, indicating that the printhead blocked more, the need to plug the printhead out, with absorbent cotton paper, dipped in water, gently scrubbing the printhead, the need to the edge of the printhead and the internal color traces of scrubbing, and absorbent cotton paper in the nozzle coated with a look to see whether ink is fluent in the paper color, if normal, you can print the printhead into the cartridge, and print to see the results. Print to see the effect.
3. you can use a straw to unblock the nozzle, so you can quickly clean and install the print to see the results. If the absorbent cotton paper to clean the printhead, the print effect is still color fuzzy, indicating that the printhead itself is more blocked, you can use a straw to unclog the nozzle, so that can be quickly cleaned and installed in the cartridge, print to see the results.
4. can use ultrasonic cleaning tools, through the vibration of the nozzle in the things washed out. When using a straw to dredge, the print effect is not good, you can use ultrasonic cleaning tools, through the vibration of the nozzle in the things out of the wash, wash, pay attention to the need to add water and diffuse over the nozzle, you can use your hand to clean, so that the operation is more convenient. The water will change color after a while, the small ink droplets to clean out.
5. Find the old printhead, add ink to use, see the print effect. When the use of ultrasonic cleaning tools can not clean the printhead, you can look for used printheads, some printheads run out of ink, but the nozzle is normal and not blocked, you can use, and add ink to this printhead to use.
6. Purchase a new printhead of the same model, with a test page to see the print results. When the printhead is cleaned in many ways, there is no effect. There is no old non-blocking printhead to add ink to use, then you need to buy a new printhead of the same model, if you have been using a blocked printhead, the printout of the picture is not good, it will cause waste, but also damage to the printer.
Printer Ink in Printers & Supplies
Printer Ink & Toner – Quality Ink & Toner Here
Inkjet Printer Ink Cartridges
All-in-One Inkjet Printer
Post time: May-04-2024