1: The cleaning solution is packed in the ink cartridge to clean the nozzle
Steps: (1) Fill the cleaning solution into the printer cartridge
(2) When the printing quality deteriorates or the wire breaks during the test mesh, install the ink cartridge containing the cleaning solution according to the normal method of replacing the ink cartridge
(3) Perform the print head cleaning, and execute the test mesh program after cleaning until the mesh test is normal, for the color cleaning liquid, the cleaned mesh
The test can directly see the effect after cleaning, and the cleaning effect of other cleaning solutions can be loaded with ink cartridges for mesh testing.
(4) After the mesh test is OK, remove the ink cartridge for cleaning, and attach a sealing strip to the air guide tank and the outlet of the cleaning liquid for reuse.
2: The cleaning solution is packed in the utensils for soaking and cleaning the print head.
(1) Take a clean utensil and pour a small amount of cleaning liquid into it
(2) Remove the problematic nozzle and soak the nozzle in it, so that the cleaning solution does not reach the nozzle board and contact plate (to prevent short circuit or damage caused by wetting with water)
(3) The soaking time depends on the plugging time of the nozzle, just the plug can not be cleaned and the nozzle can be taken off for 1-5 hours, and the delay time can be soaked for 12-24 hours
Post time: Apr-29-2024